MaglevParts
Made in
Applies to every table and search
Catalog / Builds / Build a legged robot

Build a legged robot

The bill of materials for a quadruped or humanoid: high-torque joints for the hips and knees, motors and reducers if you build the legs yourself, encoders, drivers, servos for hands and small joints, and onboard compute for perception and control.

Leg joints

Hips and knees carry the body and take the impacts of every step. Many legged robots use backdrivable, low-ratio joints for this.

81 parts in all. Open a list above to filter by size, torque and where it is made.

Or build the leg joints

An outrunner or frameless motor with a planetary reducer is the usual quasi-direct-drive leg joint. Every part one joint needs.

109 parts in all. Open a list above to filter by size, torque and where it is made.

Encoders

Joint position for balance and gait control.

90 parts in all. Open a list above to filter by size, torque and where it is made.

Drivers

Fast current control on every leg joint, usually over CAN or EtherCAT.

43 parts in all. Open a list above to filter by size, torque and where it is made.

Hands and small joints

Smart servos for fingers, grippers, heads and other light joints.

12 parts in all. Open a list above to filter by size, torque and where it is made.

Onboard compute

Perception, state estimation and the control policy.

30 parts in all. Open a list above to filter by size, torque and where it is made.

Test the joints

Measure torque, backlash and heat on the bench before the robot falls on them. The test protocol and bench kits.

26 parts in all. Open a list above to filter by size, torque and where it is made.

Not sure which combination fits? Send what you are building and the numbers you need, and Maglev comes back with a matched set and one fixed price.

How ordering works